Asus TS150-E2 Uživatelský manuál stáhnout pdf (Strana 60)

Chapter 4: Motherboard informationChapter 4: Motherboard information

Chapter 4: Motherboard information

4-124-12

4-12

2.2.

IDE connector (40-1 pin PRI_IDE1)IDE connector (40-1 pin PRI_IDE1)

IDE connector (40-1 pin PRI_IDE1)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra

DMA 100/66 signal cable has three connectors: a blue connector for

the primary IDE connector on the motherboard, a black connector for

an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),

and a gray connector for an Ultra DMA 100/66 IDE master device (hard

disk drive). If you install two hard disk drives, you must configure the

second drive as a slave device by setting its jumper accordingly. Refer

to the hard disk documentation for the jumper settings.

• Pin 20 on the IDE connector is removed to match the covered hole

on the Ultra DMA cable connector. This prevents incorrect insertion

when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

P5CR-VM

P5CR-VM IDE connector

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE1

PIN 1

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 133 134

Žádné komentáře

Asus TS150-E2 Uživatelský manuál Strana 60