Asus P8C WS Uživatelský manuál stáhnout pdf (Strana 136)

5-2 Chapter 5: Multiple GPU technology support

Chapter 5

5. Connect two independent auxiliary power

sources from the power supply to the two

graphics cards separately.

6. Connect a VGA or a DVI cable to the

graphics card.

4. Align and rmly insert the CrossFireX

bridge connector to the goldngers on

each graphics card. Ensure that the

connector is rmly in place.

5.1.3 Installing two CrossFireX™ graphics cards

The following pictures are for reference only. The graphics cards and the motherboard

layout may vary with models, but the installation steps remain the same.

1. Prepare two CrossFireX-ready graphics cards.

2. Insert the two graphics card into the

PCIEX16 slots. If your motherboard

has more than two PCIEX16 slots,

refer to Chapter 2 in this user manual

for the locations of the PCIEX16 slots

recommended for multi-graphics card

installation.

3. Ensure that the cards are properly

seated on the slots.

goldngers

CrossFireX bridge

(bundled with

graphics cards)

1 2 ... 131 132 133 134 135 136 137 138 139 140

Žádné komentáře

Modelle	Dokumententyp
5010590006	Datenblatt Funkwerk WI1040n, 9 Seiten
5010590013	Datenblatt Funkwerk WI1065n, 10 Seiten
5401092740	Datenblatt Funkwerk W2002 Access Point, 4 Seiten
5510000101	Datenblatt Funkwerk W500, 3 Seiten
5510000165	Datenblatt Funkwerk Bintec W1002n, 7 Seiten
5510000352	Datenblatt Funkwerk W2003n, 10 Seiten
5530000036	Datenblatt Funkwerk W150N, 15 Seiten
5530000173	Datenblatt Funkwerk W1001n, 7 Seiten
700176	Datenblatt Funkwerk W1002 Access Point, 5 Seiten
700177	Datenblatt Funkwerk W2002 Access Point, 5 Seiten
Bintec WI-Client	Spezifikationen Funkwerk Bintec WI-Client, 21 Seiten
WI2040n	Bedienungsanleitung Funkwerk WI2040n, 432 Seiten

Asus P8C WS Uživatelský manuál Strana 136